"Netfs", "Runlevel" Warnings During Update, Repeated Gwenview Crashes After

[Digital_Resistance]

I am running PCLOS 2011.6 KDE and just did a complete update. I have copied below the output generated by Synaptic.

Gwenview also started to repeatedly crash on me, especially in browse mode whenever I scroll past a certain point in one or more folders.

I had not had this problem during extensive use of Gwenview over the past several weeks, so I wonder if it is related to the Synaptic errors.

Code: [Select]

While installing package net-snmp-5.6.1-1pclos2011:

Warning: netfs is needed by snmpd in runlevel 3
Warning: netfs is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 5
Warning: netfs is needed by snmpd in runlevel 3
Warning: netfs is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 5
Warning: network-up is needed by snmpd in runlevel 4
Warning: network-up is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 3
Warning: netfs is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 5
Warning: netfs is needed by snmpd in runlevel 3
Warning: netfs is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 5
Warning: network-up is needed by snmpd in runlevel 4
Warning: network-up is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 3
Warning: netfs is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 5
Warning: netfs is needed by snmpd in runlevel 3
Warning: netfs is needed by snmpd in runlevel 4
Warning: netfs is needed by snmpd in runlevel 5
Warning: network-up is needed by snmpd in runlevel 4
Warning: network-up is needed by snmpd in runlevel 4

While installing package libmesaglw1-7.10.3-3pclos2011:

useradd: user 'saned' already exists

While installing package ldetect-lst-0.1.291-3pclos2011:

set_tcb - switch between tcb and shadow password schemes
version: 0.7 - $Id: set_tcb 837 2008-12-16 18:59:48Z vdanen $

 * /etc/pam.d/system-auth already uses pam_tcb!  Nothing to migrate!

[mozzie]

I had a similar problem with a completely different install.
These messages disappear if you start the netfs service in
Control Center > System > Manage system services
Set it to start at boot, too.

Hope it works for you. If it does, mark this SOLVED.

[Just17]

I had not had this problem during extensive use of Gwenview over the past several weeks, so I wonder if it is related to the Synaptic errors.

Those are not error messages ......  they are informational and warning messages, and can generally be ignored.