Adding Hardware After Install (SOLVED)

[RET423]

I have PcLinux 2009 running as a web server and it has been doing a great job for the last couple of months. I would like to add a second NIC card to the system to further utilize this box on my network but I am not sure how to go about it.

I am trying to avoid a complete reinstall even though I would rather be running the 2010 beta2 because I don't want to go through all the Apache, PHP and MySql issues I had originally when I set this up.

I added the second card and booted the machine but the OS did not notice the change.
I then booted to the live-cd and the second card was seen and configured (ADMtek NC100 "tulip" module)
Is there any way to extract this driver from the live-cd and use it to bring up the card in my 2009 install or am I looking at starting over with a fresh install?

Also, is it possible to upgrade my current install to the beta2 2010 without destroying all the software I have installed or crippling my current configuration?

Any help would be appreciated, thanks for looking!

[scoundrel]

In PCC hardware does the second nic show up there..??

as for your other question..upgrade to beta2= No

[RET423]

No, after I rebooted pcc still just shows the eth0 interface.
When I boot to the live-cd both cards are identified and the drivers are loaded fine though.

[luikki]

go to pcc, system, manage system services..., and enable harddrake.
reboot. your new card should show up...

[RET423]

go to pcc, system, manage system services..., and enable harddrake.
reboot. your new card should show up...

That did the trick! Thank you!
I am going to try and figure out how to mark this solved.

[scoundrel]

go to pcc, system, manage system services..., and enable harddrake.
reboot. your new card should show up...

That did the trick! Thank you!
I am going to try and figure out how to mark this solved.

just click on modify on your first post

[RET423]

Done, thank you!