I was preparing data to burn on a DVD and ran a 'trial-run' in
K3b, with the Simulate box checked ('ticked').
After the 'simulation' succeeded, I added some more data,
and tried it again. I was shocked when K3b told me it needs
a blank medium for simulation - as far as I knew there was already
a blank disk in the drive! But when I checked, I found that K3b had
'destroyed' my dvd disk - by WRITING the partial data it was
supposed to simulate.
I have used this option many times, but this is the first time
under FullMonty. Could that be connected to the problem?